Wireless

Does anyone know of, or have any instructions on performing an upgrade from a 4402 to 5508?

The web GUI timeout on my AP seems to be too short, if I login and sit idle for about 60 seconds when I select a different menu item I need to type in my credentials again. At that point I notice that on the login menu it says to login for priv acces...

I want to deploy a WLAN over a campus with a large number of buildings (3000+ users). On the whole campus there should be the same SSID so that no matter where people go, they always perceive the WLAN as "the same".Now, of course I do not want to mak...

Hi I wonder if anybody has seen this problem in  bridged netwrok environment. We have a pair of Cisco 1310 bridges configued betweeen 2 buildings the config on each is simple one as a root bridge the other as non root no spanning tree is running and ...

HelloIs it possible to broadcast 18 ssid for one ap group on the wlan controller?Whats is the limitation for ssid broadcast?regards,Alex

Dear,Does ASA 5540 support BGP routing protocole to be configured on it??im talking about the latest versions thanksAhmed

We have two wlc in the system 5508 and 4402.we config HA for 2 wlc, both wlc enable LAGWhen I connect 2 interface  of 5508 to 2 interface (in a port channel mode on, trunk, dot1q) of acouple of VSS switch, I cant management 5508 through web any more,...

Does anybody have config guides how to configure a 887W with an embedded AP?

Dear Folks,I have noticed a strange thing during deployment of 5500 series controller. I could only access controller from Wi-fi and from VPN network.Accessing controller from LAN wasn't possible. Could you please advise on how it can be resolved?Sen...

Hello All,I know this has been talked about a few other times, but here's the issue I'm running into and would appreciate any assistance. I'm trying to tie in LDAP to my WLC for wireless web-authentication. This setup works when I have a simple OU co...

Dear all,I have a 5508 WLC and i am configuring it to support for wireless Vlans, i have configured the vlans on the core switch, then i have connected the WLC to the core switch using two cables, and enabled LAG.I have also configured an interface f...

Hi,There is problem in Cisco unified wireless deployment in my scenario. There a multiple locations in the environment and hence we had to implement separate WLC solutions for each location. In the same we implemented different unique SSID in each lo...

Hello, I configured a dhcp server on an aironet 1042, works ok but I want that listen only on wireless interface. When I connect a PC with LAN, it takes dhcp adreessThanks.