WCS maps adding AP problem

[Vicki Cullis]

Hi,

I'm new to WCS, so I'm sorry if this is a dumb question.  I'm trying to add our existing APs to the Floor Plan and when I get to the "Position access points on Floor Area" page, I can see my selected APs in the upper left hand corner.  I can select one, which highlights it blue, but it will not move when I try to drag it.

Any ideas why this might be?

Thank you,

Vicki

[Scott Fella · Accepted solution]

Have you tried a different browser?

Sent from Cisco Technical Support iPhone App

[Vicki Cullis]

Thank you!

I knew it was a stupid question!

Chrome didn't like it.

Thanks again!

[Scott Fella]

No problem... so did another browser work fine?

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[Vicki Cullis]

Yes, that was the problem.  It is fixed now.

Thanks again.

[Scott Fella]

Chrome is the supported browser in the newer platforms.

Sent from Cisco Technical Support iPhone App