Wireless

Dear All,Kindly interpret the following error message from my LAP as the AP is not associating with the controller.1 00:01:01.385: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER*Mar 1 00:01:01.388: %CAPWAP-3-ERRORLOG: Discovery respons...

Hello all,Is anyone aware of the CLI command to enable / disable the DHCP Addr. Assignment required WLAN option on a 5508 controller running 7.2.110.0 code? I don't seem to be able to find it documented anywhere, and if it is available via CLI it's n...

<br mcebogus="1"></p>

Hey guys,I am running WLC 5508 and WCS version 7.0.98.  We are noticing with some of our handheld devices that have Sychip Wireless cards that they constantly have issues communicating.  The error I see on the WCS side is shown below:       Is this a...

Dear All, I have just checked cisco website about Cisco Prime Home and there is no information on website that contains Cisco Prime Home product codes. Can you please share Cisco Prime Home ordering guide if it is available ? ThanksKind Regards

Does anyone have any other method of staging/priming their Cisco 1552 mesh access points?  I have four to work with for a pilot, but they did not come with bench power supplies or power cords.  They'll power up with 802.3af power, and even a power in...

I am experience multiple clients dropping at the same time off of AIR-LAP1252AG-A-K9 access points when the client count is over 20 clients.Is anybody else experiencing this? Is there a client count limitation on the 1252? I don't recall seeing that ...

i did outdoor Survey & AP was able to reach distance 200 Meter with Signal strength as good on laptop ( -65dbm )a colleague told me that theoritically a client ( laptop ) cannot be far from AP more then 15 M as it will get signal but will not be able...

Hi AllDoes the 8500 support any SMOF SFPs? data sheet only talks about a MM based SFP.ThanksJ

Hi EveryoneJust deploying PI 1.2 for a new wireless network, in a new building. Does anyone know if:1. You can import floor plans with structural information about the walls etc directly into Prime maps.2. How do you do it.3. What sort of diagrams do...

Hello everyoneRunning vwlc 7.3.101 and encountered a smaller issue.When you enable / disable a SSID, all AP's reset their radio interfaces... causing everyone to drop their connection.Is this intentional?Thanks

This is a pretty cheesy question compared to some, but an annoying one.  I have a very nice and detailed floor plan of one of our Hospitals, however, PI's zooming ability in comparison to WCS/NCS is um.. lacking.  Anyway to up the zooming ability in ...