cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
573
Views
0
Helpful
5
Replies

WCS maps adding AP problem

Vicki Cullis
Level 1
Level 1

Hi,

I'm new to WCS, so I'm sorry if this is a dumb question.  I'm trying to add our existing APs to the Floor Plan and when I get to the "Position access points on Floor Area" page, I can see my selected APs in the upper left hand corner.  I can select one, which highlights it blue, but it will not move when I try to drag it.

Any ideas why this might be?

Thank you,

Vicki

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

Have you tried a different browser?

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

View solution in original post

5 Replies 5

Scott Fella
Hall of Fame
Hall of Fame

Have you tried a different browser?

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Thank you!

I knew it was a stupid question!

Chrome didn't like it.

Thanks again!

No problem... so did another browser work fine?

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Yes, that was the problem.  It is fixed now.

Thanks again.

Chrome is the supported browser in the newer platforms.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card