WCS maps not showing connected clients
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2011 06:25 AM - edited 07-03-2021 08:10 PM
Some maps are not showing connected clients. Getting warning message saying MAP has not been assigned to any Mobility Service yet. Where do I set this? I have compared my working maps with other building maps and do not see any differences in configuration? I could be missing somthing though?
Thanks in advance.
Tandrist
- Labels:
-
Wireless Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2011 06:43 AM
I found where to assign maps to the Mobility service in the Loc-server. All is well. Answered my own question....HA!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-12-2011 10:29 AM
Hi andrist,
What version for your location appliance?
Rgds,
Billy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-12-2011 10:45 AM
2710 Appliance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-13-2011 07:33 AM
I mean the software version, I meet same issue before, after I upgrade the controller to 7.0.98 with location appliance version 6.0.101.0, the issue occur, does it same with your situation?
