Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
407
Views
0
Helpful
1
Replies

WDS configuration

anubhutia1
Level 1
Level 1

‎12-16-2014 11:47 PM - edited ‎07-05-2021 02:08 AM

Hello ! Sir,

I have one Cisco Router WRVS4400n and three AP WAP 121, i am trying to set the AP as a WDS repeater but getting trouble while authenticating the client.  When i disable the authentication mode it's connecting but as soon as i enable the security with WPA Personal/WPA Personal 2, I am getting the message as authenticating  on client & not connected. I have tried with firmware upgrade as well but it couldn't work.

 

Kindly advise, Please !

 

Regards

 

Anubhuti Acharya

Labels:
0 Helpful
1 Reply 1

Saurav Lodh
Level 7
Level 7

‎12-18-2014 11:41 AM

"    
If you use WPA encryption on the WDS link, VAP0 must use WPA Personal or WPA Enterprise as the security mode."

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card