WDS infrastructure AP

[joerg]

I have installed a wds with wlse. Now I want to add an infrastructure ap.

What have I to configure on this AP?

only wlccp ap username?

What´s about the ssid? Normally I configure the EAP method under the ssid?

Does someone have a good sample confguration wds AP / infrastructure AP?

Regards

Joerg

[rmiles]

There are a few config guides on the Cisco site that are helpful. I have used this one in the past (http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801c951f.shtml).

It answers all of the questions you have asked here.

Good luck.

[dixho]

The URL in your response does not mention anything about SSID.

Yes, you still need to configure encryption (i.e. WEP or cyphers), SSID(s), and corresponding authentication types.

[rmiles]

Sure it does...http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801c951f.shtml#step3.

You may also want to reference the config guides: http://www.cisco.com/en/US/customer/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080208a6e.html.

[dixho]

You are right. I am sorry that I overlooked.

[o-ziltener]

Means that, that on the infrastructure AP you don't have to define a radius-group when you use wds?

Like this:

interface Dot11Radio0

encryption vlan 15 mode wep mandatory

ssid TEST

authentication open eap METHOD_EAP_CLIENT

aaa group server radius EAP_CLIENT

server 171.20.98.204 auth port 1645 acct port 1646

server 171.20.98.202 auth port 1645 acct port 1646

aaa authentication login METHOD_EAP_CLIENT group EAP_CLIENT

many thanks for a feedback

Oliver