We want to utilise the 4 ports on the Cisco C9800-L-F-K9 to connect AP

[jmf1982]

We want to utilise the 4 ports on the Cisco C9800-L-F-K9 to connect APs - and SVI interface on the WLC have been created on trunk TenGigabitEthernet0/1/0 with wlan 5 and 100 and - access port vlan 5 on TwoGigabitEthernet0/0/0 should these two/4 ports not communicate on vlan 5.

How to continue.

AP transcript of it to connected to TwoGigabitEthernet0/0/0

[*04/12/2024 07:51:59.8720] Waiting for preferred uplink IP configuration
[*04/12/2024 07:52:04.8800] Waiting for preferred uplink IP configuration

[Leo Laohoo]

Are you trying to connect the APs directly to the distribution ports of the 9800-L?

[marce1000 · Accepted solution]

 - This is not supported , you should connect the APs to  a switch(ed) (network) ; where then the C9800-L-F-K9 is present too for APs to connect to , 

 M.

[Rich R]

That was supported on some older AireOS WLCs but as Marce says it is explicitly not supported on 9800 WLCs.