01-25-2013 04:01 AM - edited 07-03-2021 11:25 PM
Hello,
I have a big problem. I have downgraded one of our AP1142N-E K9 to Autonomous mode with this image:
c1140-k9w7-tar.152-2.JB.tar
I have uses cisco's instructions.
After successfull installation, I can open the Webinterface, but it shows almost no information. Only Device Type end serialnumber, but nothing more.
Also it is not possible to save any configuration.
Alternatively I have installed:
c1140-k9w7-tar.124-21a.JA1.tar
Same problem. I have tried it with a LAP1252N later. Same problem.
It seems to me I have forgotton some important action.
Any hints?
Thanx
01-25-2013 05:44 AM
I would delete the image and tftp A new image. Make sure you validate the md5 after you download and then use the archive command so it sets the correct boot. I use the archive download-sw /o /r
Sent from Cisco Technical Support iPhone App
01-25-2013 08:16 AM
15.2(2) has limited web gui just to let you know. So I would stick with the 12.4 ios image.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide