Wireless 1410 Throughput Test and Security Configuration

[unnikannanvj]

Hi Team

Could you please address on the security configuration of the 1410 bridge and on how to test the bandwidth/throughput between two 1410 Bridges setup for point-to-point connectivity.

We have setup this in one of our Client sites.

Awaiting your reply.

Thanks in advance!

Regards

Unni Kannan

Systems Engineer

[Surendra BG · Accepted solution]

Hi,

here is the config example.

https://supportforums.cisco.com/docs/DOC-15193

Regarding the throughput please use the software called IPERF and regarding the BW use the command "show dot11 associations all"

Please dont forget to rate the usefull posts!!

Regards

Surendra

[unnikannanvj]

Hi Surendra

Thanks a million for your valuable inputs.

Could you also please help me on how to address the security configurations in Cisco 1410 series ?

Thanks in advance.

Unni Kannan

Systems Engineer

[Surendra BG · Accepted solution]

Its present in the link..

U can go for WPA PSK..

dot11 ssid test

   vlan X

   authentication open

   authentication key-management wpa

   wpa-psk ascii 7 cisco123

and encryption as TKIP

encryption vlan X mode ciphers tkip

Lemme know if this answered ur question!!

Regards

Surendra