Wireless AirOS Global AP Syslog Level configuration command 7.4.121.0

[Rolf Fuchser]

Hello

I have a controller 5508 running on version 7.4.121.0. With the command "show ap config global" I can check the global AP syslog config:

AP global system logging host.................... 0.0.0.0
AP global system logging level................... informational

Default the syslog host ip is 0.0.0.0. With the command ">config ap syslog host global x.x.x.x" I can configure the IP of the syslog server.

Question:

How can I configure the global syslog level?

I searched in the command reference but there is no specific command to set the global AP syslog level.

Thanks,

Rolf

[Rasika Nayanajith]

Hi Rolf,

Here is the command you required

config ap logging syslog level <syslog_level> all   

This post also should give you an idea how to configure syslog in different WLC platforms & how to analyze them using splunk

http://mrncciew.com/2014/09/19/wlc-syslog-analysis/

Pls mark the thread as "answered" if this is you looking for. 

HTH

Rasika