wireless backhaul will not allow traffic from vlan 12 and vlan 13. Native vlan is 244

[iloverton]

I have 2 APs in a mesh configuration WITHOUT an WLC.  If a wireless client connects with the root AP all vlan traffic is passed.  If a wireless client connect to a non-root AP on the native vlan 244 traffic is passed but no other vlan traffic is passed.  Can someone with with getting all vlan thru the back-haul?  I can manage the non-root ap on the native vlan.

[Rasika Nayanajith]

if it is wireless bridge, you should set it "Root Bridge" and "Non-Root Bridge" roles  with "wireless clients" keyword on respective AP's radio interfaces. See below (do not worry about EAP configuration, just initial part of config)

http://mrncciew.com/2013/11/09/wireless-bridge-with-eap-fast/

If you want to use Root AP as simple Access Point, then you have another option where you can configure far end AP as WGB. See below

http://mrncciew.com/2013/06/16/ios-ap-wgb-with-multiple-vlan/

HTH

Rasika

*** Pls rate all useful responses ***

[iloverton]

thank you for your answer, but the design calls for 802.11a backhaul.  you are using 802.11g for backhaul and clients.  We need to use 802.11a to bachual all vlans.

Thanks

[Rasika Nayanajith]

if you use Radio1 interface (instead of Radio 0) then it should be 802.11a. You can use given configuration as reference and modify as you want.

HTH

Rasika

[iloverton]

configs are attached.  thanks

[iloverton]

Configs are attached in first post.