04-02-2018 01:27 PM - edited 07-05-2021 08:27 AM
Hi,
I hope that you are doing good.
I want to configure a Cisco isr 829 as bridge router (i want to connect it in ssid that is configured by other access point(cisco 1800), and the client that connect in wired ports with isr 829 can connect in internet).Can you please help me?
04-02-2018 10:57 PM
Please check these guide:
https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/68472-configure-wgb-00.html
https://rscciew.wordpress.com/2014/10/26/autonomous-ap-as-wireless-bridge/
Regards
Dont forget to rate helpful posts
04-04-2018 10:51 AM
Hi ,
Thank you so much for your reply.
For me i have lightweight access points that will be the roots.
How i can configure them by WLC?
Thank you.
04-04-2018 02:28 PM
Hi,
We can make a network mesh between two access points with differents reference (air-1532 with isr 829).
Thank you
04-04-2018 10:25 PM
Hi,
If you want to configure as work group bridge in Unified enviounment (with WLC and LAP )then follow this guide:
here is my posts about it:
https://rscciew.wordpress.com/2014/08/15/wgb-with-multiple-vlan-in-uwns/
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: