wireless bridge with 2602 and 1262

[rschwart]

I have been tring to build a bridge with a 1262 on one end a 2602 on the other and not having any luck connecting. The 2602 replaced a damaged 1262. I only use the A radio for the bridge. Any suggestions on the config?

[Sandeep Choudhary]

Hi,

please check these configs:

https://supportforums.cisco.com/document/61936/autonomous-ap-and-bridge-basic-configuration-template

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68087-bridges-pt-to-pt.html

Hope it helps.

Regards

Dont forget to rate helpful posts

[Scott Fella]

You should be able to use your old configuration, there might be some differences depending on the code you were running, but it should work.

[Rasika Nayanajith]

Pls attach two AP configurations to check 

Rasika