09-15-2017 06:16 AM - edited 07-05-2021 07:39 AM
Hi
Anyone here that got experience with configuring wirless guest authentication with fortiwlc(Meru) and Cisco ISE ?
If someone have some information or can give me a clue how to proceed with this it would be much appreciated
09-15-2017 05:49 PM
09-28-2017 06:20 AM
Thanks Francesco I wil try to set it up some day ;)
09-28-2017 05:13 AM
Hi there,
Did you manage to set this up? I'm looking to do the same.
Thanks
Tim
09-28-2017 05:16 AM
Hi
Yes, I did it using Cisco ISE 2.2 with DHCP scope.
The goal is that ISE gives IP addresses within a specific scope and it will add itself as dns server. Then it can catch all traffic and send a redirect.
This is the way I'm doing it and it works very well.
Sending the url redirect to the device, it's sometime a challenge depending on vendor.
Thanks
09-28-2017 06:21 AM
I have not been able to test this but i wil let you know when i have tested it out :) Hope you wil do the same :)
03-13-2021 10:38 PM
who know when when i change battery after run it shows below
ÿÿBBBBBBâBÂBBBBþ2BBBBþÿÏÿBBä##bBBòkÿBBBBBB?BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBõBBBBBBBBBBBBÏÙBBBB¯BBBâ¯BBBâÿ¯BBBâʽr?±BBBBòÿ¯BBBâ¯BBBâÅýÿ¯BBBâ¯BBB?ýÿ -¨+^që=,],Õýµ³Ñ¬'?½±[f]î',¥,¥,U¥¥mR*r©*±¯¦õìJµ?(© ¬ ($´u¡4$G4$¡(Tl ²ì5sÔÄB K¡?>« ûBÄþ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide