because if I service-module wlan-ap 0 session to give than I get
Trying 10.10.10.1, 2002 ... Open
Connecting to AP console, enter Ctrl ^ followed by x,
then "disconnect" to return to router prompt
User Access Verification
User: Tim
Password:
ap:
when I start it back I get this message on wireless module
IOS Bootloader - Starting System.
Xmodem file system is available.
Bringing up flash filesystem:
flashfs [0]: 5 files, directories 1
flashfs [0]: 0 orphaned files, directories orphaned 0
flashfs [0]: Total Bytes: 31,481,856
flashfs [0]: Bandwidth used: 38400
flashfs [0] Bytes available: 31,443,456
flashfs [0]: flashfs fsck firing nine seconds.
Reading cookie from flash parameter block ... done.
Base Ethernet MAC address: c8: 4c: 75: 5b: cf: a8
Ethernet Interface initialize.
Ethernet interface initialize OK.
TFTP initialize OK.
button is pressed, wait for button to be released ...
button pressed for 31 seconds
process_config_recovery: Set IP address and config to default 10.0.0.1
Flash: /cpconfig-ap801.cfg: no such file or directory
Configuration restore return 1
The system will go into bootloader for image recovery.
User can download image under bootloader prompt.
ap:
