Wireless

Hi Device NAME: "Chassis" , DESCR: "Cisco Aironet 1850 Series Mobility Express"PID: AIR-AP1852I-Z-K9,  Product Version.................................. 8.2.100.0 My problem  Last Reset....................................... hardware watchdog reset S...

I have a cisco vMSE running the cmx analytics version 8, the vMSE is a low end I was checkinng a cisco´c documentation and I can saw that the low end is not rupport the CMX license, but if I look at the vMSE license I can look the cmx analytics, so w...

I am unable to access the service port address of 192.168.1.1. My PC is set to 192.168.2.1. Can you please help me.

Hi,   we have some AIR-ANT25137NP-R antennae and are after purchasing some AIR-CAP3602E-A-K9.  Will these antennae work with these APs?  Can you leave one of the cables loose for each radio? Thanks, Hugo.

Hi Everyone, An access point has 1Gig port connected to access layer switch on 1Gig port. How it achieves the 450Mb per user on 5Ghz 802.11ac  where 20+ users are connecting. Regards, Beacon

  Hi,   I just got a new Aironet 2700e AP and need to change it to work in autonomous mode (I already have ap3g2-k9w7-tar.default file) however I'm unable to update it mainly because:   1. After booting when getting the "ap:" prompt I'm unable to ent...

Hi, I have got a requirement to deploy traffic engineering for the guest wireless. Conditions are 1.  bandwidth should be controlled based on venue/site, user & access-point level. 2. Some users need to have limited time access. Some should have unli...

Hello Experts, I am using webauth with sleeping client feature for guest clients. Problem : 1. When my mobile goes in sleeping mode then i can see the entry of the mobile mac in Sleeping client list but when I use my mobile again then i need to use/o...

Hi, I got a scenario where same SSID is being advertised to different sites. All users are authenticated via Webauth. Customer is asking me to enable venue based Captive portal. Conditions are 1. Web auth- Captive portal should have layout based on t...

Hi all, We have 5508 controller connected to N9K in ACI mode and using 3602/3700ap`s. AP`s is connected to 3560x edge switches. We have bad AC performance, max 20-23MB/sec with cifs filecopy or http/ftp client linkspeed is 866mhz, 80mhz channel. Clie...

Hi,  When a mobile phone with Android 6.0.1 wants to connect to WLC 802.1x wireless network user cannot pass the authentication. We searched the ACS logs failed attempts and we saw the below fail log. 17/08/2016,13:59:01,Authen failed,name_surname,Do...