12-14-2011 03:37 PM - edited 07-03-2021 09:14 PM
Lame question. We are going to move our WiSM blade from one 6509 to another. It is being removed from Module 2 and placed in the other 6509 Module 2.
~ Current IOS - disk0:s72033-advipservicesk9_wan-mz.122-18.SXF7.bin
~ Move to IOS - disk0:s72033-advipservicesk9_wan-vz.122-33.SXI3.bin
Question I have is will this work with different IOS Versions? What steps do I need to do to make this move seamless?
Any help/suggestions would be greatly appreciated.
Sincerely,
Joel
12-14-2011 05:20 PM
What steps do I need to do to make this move seamless?
Errrr ... can't make it seamless because once you remove the blade from the slot the WiSM powers down.
12-14-2011 06:07 PM
What I mean in regards to seamless is I know we will lose WIreless clients. I want to preserve a fast recconnect so this is what I'm aiming for.
Not sure if it is as simple as plugging WiSM in and verify configs are same previous 6509 Config?
12-14-2011 07:56 PM
I just did a large wism move myself. A few items to consider.
layer 2 is the same on the new cat
interfaces on the new cat has proper multicast set (pim) etc
use autolag setting up the wism on the new cat
insure you have enough power on the new cat to support the wism
I dont know anything about your move or your design so i would cross check it cat. as for the code you should be fine
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide