Hi,
I have WiSM with IOS version 7.0.240 (newest available - both controllers have the same version upgraded)
The problem is:
One laptop connected to AP "A" (CISCO 3502) which is connected to different cabinet using CISCO 2960S to WiSM A using CISCO .
This Laptop connects and can see clients in the room (in area of AP "A" with the access point wired too .
Another Laptop connected to AP "B" (CISCO 3502) which is connected to different cabinet to WiSM B.
This Laptop connects and can't see clients in the room (in area of AP "B" with the access point wired too.
Both laptops share the same SSID in the same subnet in the same 6509 core switch , but on different WiSM.
Broadcast forwarding is enabled
It's look like this:
Laptop A ---->>> AP "A" 3502 ------C2960S ----- WISM "A" on core 6509 WiSM "B" ------C2960S --------AP "B" 3502 <<<----Laptop "B"
All laptops are new, the same setup imaged, the same subnet.
The question:
- why laptop B can't see any clients in area of AP "B" but laptop "A" can.
There's no filtering between on core 6509, 2960S and any WiSM. All traffic is passed.
Regards
Piotr
