WISMs HA session access issue

[ahmedfouad]

Hello ,

kindly i have 2x WISM2 installed with HA ver 7.6.120 , the strange thing that i can not access the WISMs through 6500 CLI via session command .

it gives me connection refused by remote system .

but before HA i could .

the service port IPs  are assigned by DHCP as per recommendation of Cisco for HA .

thanks,

Fouad

[Leo Laohoo]

You mean you can't access the secondary unit.  And this is correct.  It depends on what IP address you are using to reach the secondary unit.

[ahmedfouad]

i can not access either Primary or secondary via service-port through session command always give connection time-out ,  however they are pingable and working normally in HA mode .

and this is for all WISMs that i have at multiple 6500 switches .

[Leo Laohoo]

i can not access either Primary or secondary via service-port through session command always give connection time-out

Can you please check that the Management VLAN of the WiSM is in the "allowed VLAN"?

[ahmedfouad]

 yes , the service vlan is allowed  this is for sure in addition to the MGMT and data vlans .