WLC Mode: AIR-WLC2125-K9
Version: 7.0.116.0
Here is the scenario, we have two WLC, one is located at SG and the other is located at MY (In test stage).
Both WLC has configured with three Country Codes CN,MY and SG , as well as the Regulatory Domain 802.11a -CS and 802.11bg -ACE).
Yesterday we did perform WLC failover test and it was successful but we noticed some of the APs country code are incorrect set as before, we are tried into the AP config, and pull up the Advanced Tab and select the Country where the AP is physically located but the weird issue happened whereby there are only one country code available and the other two country code are missing.
Here is the AP model we used.
AIR-LAP1142N-N-K9 (CN)
AIR-LAP1242AG-S-K9 (SG and MY)
Could someone help to advise what would be the cause how to resolve this issue.
Thanks in advanced.
