Wireless

Hello everybody, Im consulting you because Im implementing a new AP outside my office.The new AP is configured to use HREAP but it doesnt register with the centralized WLC.ping connectivity is OK between each other.This is the log on the AP:*Mar 12 1...

Hi,They are 8 APs Cisco 1240AG installed inside our warehouse, on the other hand we had some places with poor signal level -82dbm so we put two router linksys wrt54g.The Cisco APs have 2.2dbi omnidirec antennas and they are configured with the same S...

Hello, all.I am having an issue with a couple of the 1232 APs (out of 14) in one of our buildings, and I have no idea what could be causing the problem.  The issue is that basically they don't seem to be receiving/transmitting at all, even though the...

hi,I have 1242AG. how many clients can be connected to this AP??

I have a security consultat  asking about the hashing mechanism used on the user accounts of the WLC. He would like to see a standard of at least SHA-512.I've had a look around and can't see any specifics in the various config guides, FAQs etc. about...

Looking at the Cisco Aironet 3500e. When it is ceiling mounted, all 6 antennas are directed vertically towards the floor. When the AP is wall mounted, I guess the antennas should be adjusted at the hinge joint to be vertical. However, the antennas ar...

I am currently working on a project in which I am running a layer three network out to the access layer. I have previously configured a Wireless Lan Controller built into a ISR using VLAN's and subinterfaces but in my new configuration without point-...

Hi Guys,I have a setup like this:A central WLC 5508 running code 7.2 with management vlan 10 ( range 10.10.10.0/24), corp-user vlan 100 (10.11.10.0/24) with WPA2 key, guest vlan 200 (192.168.0.0/24,  on local dsl modem) with WPA2 key...A remote WLC 5...

The AIR-LMC wireless card in my AIR-AP350 SERIES (AIR-AP352E2R) router is on the blink so I want to replace it.  I see that the AIR-LMC350 Series wireless card is used in various Cisco products including PCI adaptors, are these all the same cards or ...

I have an issue with my primary WLC AIR-WLC4402-50-K9 running version 7.0.220.After a reboot of the WLC only one AP can join, all others are rejected. After waiting a few hours (about 3) all APs can join the WLC.What I have done is a software upgrade...

HI EverybodyI will upgrade my Wireless Controller Firmware 7.2.103.0But I dont know WCS will support manager new controller firmware 7.2.103.0 ?is need NCS to manager? or WCS can be manager new controller firmware 7.2.103.0 all feature? Now My hw isC...

Folks,              I have fixing a very bad design where the coverage is not good. The users are complaining that when they roam their phones get disconnected as the APs are connected to controllers in different subnets and cckm does not work well i...