WLC Config Save

[Heinz Kern]

Hi all,

our WLC has been reloaded this weekend. at the moment i´m not sure if all the config has been saved on the controller (saving config to flash). is there any possibility to see when the current config has been saved on the WLC? i couldn´t find it up to now. we are using WCS for configuration.

thx

[Rasika Nayanajith]

If you configuring WLC via WCS, when a config change push to WLC via WCS configs will be saved in controller. So reload may not loose any configs send via WCS.

But if you configure it via WLC GUI, then you have to click "Save Configuration" to save it in NVRAM. Therefore depend on the method you use for config you can safely assume whether any config was lost or not.

HTH

Rasika

[Scott Fella]

If your using WCS to backup your wlc's then you should be able to look at WCS in the scheduler or even look at the backup file file name as it will have the last date. You will not see anything on the WLC unless you scrub through the logs and as long as the logs didn't get purged.

Sent from Cisco Technical Support iPhone App