Wireless

Hello,I am trying to configure a guest tunnel between a local and an anchor WLC. I used the information posted in another discussion https://supportforums.cisco.com/message/3312270#3312270 and the config guide for version 7.2.On the local WLC I confi...

Dear Friends, I do have issue in upgrading firmware or downloading code from WLC 5508 , version 7.0. I did the same image upload with other devices through CLI from my notebook and it works fine. Everytime i try to upload/download the image, it gives...

Good morning. We want to separate the access privilege of staff and students by using the same SSID. Currently, we are using free radius linked with the Active Directory. If we want to purchase Cisco ISE, could you please tell us what kind of license...

hi,I have WLC 4400 and 50 APs attched to it.I want to take back up of both. help me on this

hiWe have offlate noticed that a few AP's keep going down at random intervals through the day.we have setup alerts in WCS throuhg which we get notification. After a restart, it seems to come back, but keeps going down again.This seems to be happening...

Hello Everyone,I am facing some problem in AIR-LAP1141N-A-K9.in this AP if 21 user connected then no one can't browse even we can't get ping from the Gateway. But if the user is below 20 then everyone can browse and we also get the reachibility to th...

I currently have a server that is operating Windows Server 2008 R2, all computers are controlled though domain from the server. The server is also sharing printer permissions to all the computers.The question that I have is when I have a guest on my ...

Hello everyone, here's full story ...I just purchased a lot of three 2nd hand AIR-CAP3502i-E-K9, that were previously set as lightweight. Since I needed autonomous APs, I loaded a 12.4 IOS first, then upgraded to 15.2(4)JA1.On first device, turning L...

Oddball Request. County Fair Grounds wants to offer Wireless access. They have a 40 foot pole in center of the Fairgrounds that they think they can mount an AP to. Coverage would be about 800ft diameter. Cisco Outdoor AP in a NEMA enclosure with omni...

I have a 3600i AP positioned vertically on a wall facing out. I know this is bad placement I am working on getting them all oriented with some new mounts for the type of office we have. How do I position this in terms of orientation and elevation. Af...

Hi Guys,Maybe someone can help me out?I just finished setting up a trial "Cisco Virtual Wireless Controller" with nearly the same configuration as our Physical "Cisco Wireless Controller" with the exception of having 2 ports.  Anyhow, I managed to ge...

Good Day,               We purchased three Cisco Aironet 1550 series AP`s with the following IOS AIR-CAP1552E-A-K9, i was told from a Cisco Partner that we would need the WLC to be able to install the autonomous image, i find this rather odd as the r...