01-24-2011 08:06 AM - edited 07-03-2021 07:42 PM
Hi,
We received this question from our Facebook community.
http://www.facebook.com/CiscoSupportCommunity
01-24-2011 08:19 AM
Hi,
Q>> If i have 4 WLC controller in the network , and want the AP register with wlc number 1 and secoundry one be wlc number two...i mean i want a spific WLC be the primary...but before the access point be power on..can i do that in WLC not in access point menu in wlc
ANS - NO.. Before powering on the AP, we cannot do this.. We just can mention the MASTER CONTROLLER so that, if the AP doesnt register to any WLC, then the AP tries to joing the master WLC.
However the second option for this is to PRIME THE AP to joing the respective WLC using the below link..
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
Regards
Surendra
01-24-2011 01:02 PM
If i have 4 WLC controller in the network , and want the AP register with wlc number 1 and secoundry one be wlc number two...i mean i want a spific WLC be the primary
Firstly, this depends on your IOS. If you have a 4.X IOS, this can be done using CLI. Otherwise, you can configure primary/secondary/tertiary controllers.
but before the access point be power on..can i do that in WLC not in access point menu in wlc
DHCP OPTION 43 for Lightweight Cisco Aironet Access Points Configuration Example
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide