WLC easy question

[stephen jeffrey]

Hi, Ive got a WLC and stupidly highlighted an AP and selected remove AP. how do I get it to register again withthe controller. WLC is  version 7.0.116.0               

[Scott Fella]

How did you remove an AP? I don't see anything to remove an AP from the WLC. Connect the AP to the same subnet as the WLC and console into the AP and post the output from boot up.

Sent from Cisco Technical Support iPhone App

[stephen jeffrey]

Sorry, It wasnt until I went back through the steps I realised that Im using WCS to manage the WLC. I removed the access point from there.

[Scott Fella]

Well you can add the access point back on the map if that is where you removed it.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[Scott Fella · Accepted solution]

Make sure on the Security | AAA | AP Policies tab that you don't have the last two checkbox enabled. By default, Accept Manufactured Installed Certificate (MIC) is the only one checked.

Sent from Cisco Technical Support iPhone App