09-04-2014 06:55 AM - edited 07-05-2021 01:29 AM
Hello all, I configured 2 WLC 5508 with version 7.6.120 in HA, one of them had the management trought management-port (the primary) and the other had the management trought the service-port.
When I setted SSO enable I lost the management to the secondary and when I finished to configure the HA I tested and I can access to the GUI only when the primary is active but if the primary goes down I can't access to the GUI but everything is working fine.
Thanks in advance
09-04-2014 08:15 AM
An HA-SKU controller with an evaluation license cannot become a standby controller. However, an HA-SKU controller with zero license can become a standby controller.
It is not possible to access the standby-hot controller through the controller GUI, Cisco Prime Infrastructure, or Telnet. You can access the standby-hot controller only on its console.
After you enable SSO, you must access both the standby and active controller using:
09-04-2014 08:26 AM
The primary WLC has a licence for 250AP and the secondary has a licence for 50AP when the secondary take the primary role because of a disruption of the primary the secondary takes the licence for 250AP but I can't manage by GUI, is this a normal function?
09-05-2014 07:49 AM
Yes that is normal!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide