WLC I am trying to setup lan connection

[meliand93]

My wlc is failing to connection to the internet with a lan configuration the wlc sees that something is plugged into a port. I'm not sure how the setting should be I have followed various guides to no avail, any help would be appreciated.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_0110.html

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/dhcp.html

[Sandeep Choudhary]

Step1: Connect WLC via console and do the initial config.....

example: https://www.networkstraining.com/cisco-wireless-lan-controller-configuration/

Step2: Connect to swicthport. and use these config for that swicthport:

Example:

interface GigabitEthernet2/1
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,81,82,171,999
switchport mode trunk
no shut

Regards

Dont forget to rate helpful posts

[meliand93]

Do I enter CLI then sign in and put those commands in?

[meliand93]

How do I connect to switch port.