WLC's must have same config
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2014 01:15 PM - edited 07-05-2021 01:05 AM
Hello ,
I have three WLC's - WLC1, WLC2 and WLC3. They are part of mobility groups. I need WLC-2 and WLC-3 to have the same config of WLC-1.
If I upload the WLC-1 configs on WLC-2 and WLC-3 , will it work ?
Thanks
- Labels:
-
Wireless LAN Controller
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2014 02:30 PM
Yes, it will work.
The only thing, technically, different among them are the IP addresses and the WLC name. Otherwise, it works. I've done this so many times already.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2014 04:59 PM
Thanks for the reply Leo.
So after copying the configs I need to unplug the WLC-2 and WLC-3 , console in and from CLI need to change the management IP address.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2014 12:20 AM
Hi,
upload the config from WLC1.
Make changes(Ip adderss..and dynamic interface ip...etc) in config for WLC2 and then download to WLC2 by chossing command > Download from wlc gui, and same for wlc3.
Regards
