cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2195
Views
0
Helpful
2
Replies

WLC snmptrap messages

aydinnmu1
Level 1
Level 1

Hi,

WLC 8500 send out two types log.

For system messages -> syslog

For client and access-point messages ->snmptrap.

We want to track these snmptrap messages. In WLC User interface trap messages are readable. "Client abc associated in wlan abcd."

But we cannot read messages on any snmptrap receivers application. All messages seems just oid and their values.

"1.3.6.7.25.34.98 = abcd."

How to merge these oids and their description to make more readeable.

Thanks for all.

2 Replies 2

PETER MOOREY
Level 1
Level 1

It sounds like your SNMP trap receiver application doesn't have the SNMP MIB files required to map the OID to a description.  You can download the MIBS for the WLCs from the Download section as described below.  Once you have the file/s you will need to reference them within the trap receiver application, usually be putting them into a certain folder, it varies by application.

Products -> Wireless -> Wireless LAN Controller -> Standalone Controllers -> Cisco 5500 Series Wireless Catalyst -> Cisco 5508 Wireless Controller -> Management Information Base (MIB)

There is a similar discussion on this at the link below too-

https://supportforums.cisco.com/discussion/11268776/problem-wlc-and-snmp-ap-assocdisassoc-trap-and-3rd-party-nms

Pete.

Saurav Lodh
Level 7
Level 7

Check the MIBs for the controller

http://software.cisco.com/download/release.html?mdfid=282600534&softwareid=280775088&release=7.6&relind=AVAILABLE&rellifecycle=&reltype=latest

CISCO-LWAPP-AP-MIB.

Review Cisco Networking for a $25 gift card