Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
hi all, i got a WLC 2504 connected to a WS-C3560X-24P. the issue is whenever there's a power issue on the remote site, users reports they're unable to use their wifi. i always need to manually bounce the trunk port on the switch that's connected to W...
Model is 1832I-B-K9 I cannot get the AP to boot up for Mobility Express. I have the AP installed on a completely isolated network so it is not getting any DHCP option 43, DNS resolution, or L2 broadcast response from a controller. Switch has local ...
is it possible to configure cisco aironet 1702i without wireless controller ?????
Situation/configuration is as follows: - WLC 2504 (8.1.131) with a total of 22 AP's connected. - Several WLAN's active each having there own (dynamic) interface - The (static) management interface has the "enable dynamic AP management" option enabled...
Hi, I need help configuring the Access Point 702W device to a specific IP address. Is there a step by step procedure I can refer to? Also does it need a controller external interface to configure it or can I download a software to change configuratio...
1 WLC 2504, 2 Access Points and 1 netgear prosafe router connected to Cisco sg300 switch. We have 16Mbps leased line for 30 members. The MRTG graph of leased line ISP shows very less usage of internet but the speed we experience is very slow browsing...
Hi, AP is unable to join wireless controller. There are 18 AP's at the site, out of them 7 is not showing on controller. Its getting IP address from DHCP & able to ping from WLC. It is showing in CDP neighbour details. Also we have checked the countr...
In our company HQ we have QNAP NAS TS-879U-RP as SAMBA file server. We have remote office with ASA 5506 connected to HQ by VPN. Users in remote office can connect to NAS only if they connected by LAN cable to ASA, users connected to ASA by WiFi (Cisc...
Hello gedlemen. Before continue to my Q. I would like mentions the critical and how usable is this community for us , people who they are using cisco devices . Thanks for All. Now my questions is . There is in roadmap of cisco company , the switc...
I have done 40-50 deployments using CT-2504s and 6-15 access points, mainly in high end residential environments. I now have a commercial job, that will have 18 APs ( 17x 2800 series, and 1x 1560 Outdoor).. The client is very concerned about wireles...
The company I work for has required Radius authentication for wireless users. In order to get on wifi, the PC and the user need to be in AD and the user needs to be in an AD wifi group. This security seems to make a lot of sense except for one issu...
I configured the WLC C3650 with AP 1852iIt is OK to join AP and assign IP to client's devices (notebook, smart phone) even can ping to external DNS address.but Clients can not access to web site. there is so strange symptom that Client can access to ...
On a 5508 with 7.4.110 code I have clients going out the global interface (on the WLAN itself) rather than the interface stated in the AP Group config. The users are then just hanging and not getting a DHCP address. I verified the AP(s) are in the g...
Hi all, I have a new Cisco 2504 Controller with the latest firmware and a lot of 1832 APs. The APs have joined succesfully to controller and then I have changed the AP Mode to Flexconnect. After that the APs are not anymore in the "AP table" of the c...
Hello, I contact you for an issue about "Web auth on mac failure with anchor and Clearpass".My SSID "Guest" is redirect to a controler anchor on DMZ.When I try to connect for the first time, I am redirected to Captive Portal Clearpass and I am authen...
