I've recently changed my DHCP pools on my 5508 controller and am now plagued with traps this morning for the error: DHCP address pool recover. Scope: <scope>. I don't think there's anything going on that shouldn't be (?) so is there any way to suppress these traps? I looked in the management section of the gui but couldn't see anything.
When you changed the dhcp pool, did you reboot the WLC? You might have devices that have existing dhcp that could be the issue. You could always try to delete and then create the scope again.
When you changed the dhcp pool, did you reboot the WLC? You might have devices that have existing dhcp that could be the issue. You could always try to delete and then create the scope again.
