cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
339
Views
0
Helpful
1
Replies

WLC2500 problem

joyride_us2
Beginner
Beginner

Hi!

I have an issue with my WLC2504 box. After some manipulation of the box :

- I cannot reset the config : it comes back to the config I had set in

- I cannot use the Console port any longer (?) 

- the only way to access the console mode I have, is through the AP 1832I console port...but the controller does not accept the administrator password. Dead!

Let's start there!

Jeff

1 REPLY 1

M. Wisely
Enthusiast
Enthusiast

Connect to the console port reboot the controller. Shortly after it starts booting you'll be prompted to hit esc to enter a boot menu. Hit esc and you will be prompted to select an option, one of this is Clear configuration.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/2500/quick/guide/ctr2504-qs.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: