WLCCA 4.0.6 Beta refresh

[Javier Contreras]

New 4.0.6 WLC Config Analyzer Version

https://upload.cisco.com/cgi-bin/swc/fileexg/main.cgi?CONTYPES=wlc-conf-app-dev

Fixes included

• Fixed parsing error on rogue detection
• Fixed exception if controller had zero interfaces (incomplete file)
• exception on mDNS parsing
• Find AP function optimizations
• Error parsing on Number of Radios
• SNR Graph not displayed
• IOS-XE controller tree cleanup
• Search MAC bug issue

[Flavio Boniforti]

Hi Javier.

Are there any reasons, why I should not use version 4 (beta) of WLCCA?

And... is version 8.1.111.0 supported?

Thanks and regards,

Flavio.

[Javier Contreras]

hi Flavio

>Are there any reasons, why I should not use version 4 (beta) of WLCCA?

no, you would benefit of several new fixes and features

and you would be able to report if there is anything broken ;-)

>And... is version 8.1.111.0 supported?

yes it is

regards

[Flavio Boniforti]

Hi Javier.

I was actually looking at the configuration of a 4404 (7.0.230.0) and I couldn't find the "Flexconnect" entry under "Best Practices Summary - All Controllers". Can you explain why?

Thanks and regards,

Flavio.

[Javier Contreras]

hi

Flexconnect is only reported if APs in flexmode are found, otherwise it is not reported.

On 7.0, AP mode is written as "H-Reap", so it is possible that the best practice logic ignores them

regards

[strembla]

Hello, I hope I'm at the right place to report a bug .. Under access point, RF Summary, right click and copy content to clipboard no longer works , thanks

[Javier Contreras]

hi

The best place to report a bug is email to wlc-conf-app-dev@cisco.com, thanks!

I took note of the problem report, we will check for next beta refresh.

Regards