Wireless

Good morning, In one of our sites we have 2 Catalyst express 500 that are responsible for the LAN switching on that local. We only had there one access point till now one old Aironet 1240AG that worked perfectly connected to the switch with the smart...

Hi GuysWe are deploying an Anchor Controller (2504) to terminate our Guest SSIDs. We are using new mobility to support a mix of 3850, 5508 and WISM2 controllers.  SSID1 (Guest) - Open with Layer3 Web Authentication on Anchor controllerSSID2 (BYOD) - ...

hello,I have a hardware-failed device Cisco 2106 from which I have the configuration.   I have a new 2106 device.  Is there a way to move / import / copy the old configuration into the new 2106 ?Thanks PS  I have the show run-config commands 

I'm running version: 8.0.120.0 and would like to know if there is a way to manually change the hostname without using the setup wizard?

Hi All,We are facing some weird issue after applied the initial configurations and first reboot in our MSE 7.6. Even we double checked and corrected our NTP settings. Additionally, we disabled the system cryptography to use FIPS. All looks fine, howe...

Hello everyone,I'm currently using a 3702E AP in Autonomous Mode for some performance tests and I would like to monitor the following parameters: SNR, RSL and SIR. However, I was enable to find these parameters among the variables provided by the MIB...

Hi allThis maybe a dumb question, when connecting a root ap to a mesh ap, do they use the same channel to connect to each other?cheers  

hello everybody, a few months ago Peter (see attached reference) wrote that the new 2700 AP will receive a new Single, Unified Software Image - where apparently this image could be used for Autonomous Mode as well as for Controller Based WLAN communi...

Hi Team, There are alot of AP's from different sites are assocaitig to this controller. I am using flexi connect local switching. In this case while creating the dynamic interfaces lets say for vlan 10 , In ipaddress field " Specifically which Ip add...

Good Morning, I am setting up new Cisco 5508 WLC at Guetamala location. When I try to select Country Code, there is no option for Guetamal, what should I select for Country Code ?Controller Info. AIR-CT5508-K9 AP informationAIR-CAP3702I-A-K9     Than...

  I try to do a Lab, using NAT-PAT function in flexconnect AP, let wireless clients can access network by PAT translates client's IP to thin AP's IP. below is my topology:Topology work is well, clients can get private ip per WLAN, and access network ...