01-15-2013 05:49 AM - edited 07-03-2021 11:21 PM
Hi team,
We need to use this workgroup command in AIR-AP1242AG. This AP comes with the default IOS c1240-k9w7-mx.124-21a.JA1, but this does not support the command.
I tested too with IOS c1240-k9w7-tar.124-25d.JA2 without success.
Any of you knows about the version that support the enterely command: workgroup-bridge unified-vlan-client
Expect for your command.
Regards,
Mitchell
01-15-2013 06:26 AM
That command is referenced in this doc. The code is also mentioned in the doc. Hope this helps
http://www.cisco.com/en/US/docs/wireless/access_point/12.4.25d.JA/Configuration/guide/cg_12_4_25d_JA.html
Sent from Cisco Technical Support iPhone App
01-15-2013 11:38 PM
Hi,
Do you have the sub-interfaces created on the WGB with the encapsulation dot1q configuration? if not try to configure the encapsulation first then try this command.
HTH
Amjad
Rating useful replies is more useful than saying "Thank you"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide