08-05-2015 11:32 AM
Hi, all:
When configuring a NAT license for a CGSE+, what is the correct way of configuring the license in admin mode (for example a CGSE+ with an FP140 in slot2 in a CRS)?
license XC-XLAT-ANY-10M
(type permanent?)
location 0/2/CPU0
or
license XC-XLAT-ANY-10M
(type permanent?)
location 0/2/0
thanks,
c.
08-05-2015 03:00 PM
The correct format is "license <license PID> location <R/S/I>"
You may type a "?" to see the list of available slots where the license may be applied.
The CLI is also listed within the System Management Configuration Guide(s) on CCO.
You may also review the list of supported CLI options here:
http://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-0/system_management/command/reference/yr40crs_chapter14.html
08-05-2015 03:05 PM
cli will allow me to assign it to any slot:
(admin-config)#license XC-XLAT-ANY-10M location ?
WORD Fully qualified location specification
all all locations
my question was more along the lines of whether it should be assigned to what i believe is the FP (0/2/CPU0) or the cgse+ (0/2/0).
08-05-2015 03:08 PM
Hi Carlos
It would be 0/2/CPU0
Please let me know if you see any issues.
08-05-2015 03:14 PM
thanks, pretty sure the router takes both, just curious which is the appropriate way.
btw, a two-part followup:
- have you ever configured a second license to the same slot?
- what if you have two cgse with one license each, just configure both slots under the license name?
08-07-2015 01:54 PM
Carlos
Apologies for the delayed response.
Please review the following doc. Although its for ASR9k, the license infrastructure is the same.
http://www.cisco.com/web/Cisco_IOS_XR_Software/pdf/ASR9000_SWE_User_whitepaper.pdf
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide