"Subslots 0, 1, and 3 can provide up to 20 Gbps of capacity, as can subslots 2, 4, and 5. Take care not to install SPAs that require more than 20 Gbps of capacity in each group of subslots so as not to oversubscribe the card."
Tambien puedes ver a detalle lo de las Gig Ethernet.
"If you are using only Gigabit Ethernet SPAs on the Cisco CRS-1 SIP-800, then the SIP can be oversubscribed. The Cisco CRS-1 SIP-800 can pass a maximum of 40 Gbps of traffic, so if you have six 8-Port Gigabit Ethernet SPAs operating at almost full capacity, the SIP is oversubscribed"
espero esta informacion te sirva Detallo a continuacion la respuesta en ingles, para que esta tambien sirva a clientes en otros idiomas.
If you are using only Gigabit Ethernet SPAs on the Cisco CRS-1 SIP-800, then the SIP can be oversubscribed. The Cisco CRS-1 SIP-800 can pass a maximum of 40 Gbps of traffic, so if you have six 8-Port Gigabit Ethernet SPAs operating at almost full capacity, the SIP is oversubscribed
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...