Yes, I created that template,

3496

Views

Helpful

Replies

Highlighted

Yes, I created that template, however it is a copy of the default "SNMP - Generic OID Template". You can use the generic or create a separate one for IPv6.

Jamie

Latest Contents

performing a manual iPXE boot (eXR password/disaster recover...

Created by xthuijs on 05-28-2020 05:38 AM

CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot. One can also perform the operation manually, like a "turboboot" for classic XR in this facinity. this procedure will wipe out the complete system and install a... view more

Introduction to MPLS LDP and MPLS-TE and SR and SR-TE (color...

Created by smilstea on 03-24-2020 04:25 PM

Hi everyone, Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the... view more

[CVIM] Pod health check

Created by gosekar on 02-10-2020 12:24 AM

Introduction This document summarises various health checks that can be done on a Cisco VIM pod. Cloud-sanity Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc.... view more

Hardware Upgrade from RSP440 to RSP880-LT

Created by pallu on 02-06-2020 09:23 PM

Prerequisites The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful. Make sure that you have console access to the router. Verify that the system is running a minimum o... view more

BGP Flowspec implementation on Cisco 8000 platforms

Created by yosef_manasseh on 01-29-2020 01:21 PM

Feature Description BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (... view more

CreatePlease to create content