Best practise to monitor Cisco ISE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2017 04:42 AM
Hi,
We use IBM Netcool Omnibus to monitor our network. I am trying to figure out if anyone has deployed Cisco ISE in a production network and monitor it with IBM Netcool. The SNMP stack on the cisco ISE doesnt support many traps.
I may have missed something. I am not a Network engineer , I work on the monitoring development.
he SNMP Agent on Cisco ISE provides read-only access to the following MIBs:
- SNMPv2-MIB
- RFC1213-MIB(MIB II)
- IF-MIB
- IP-MIB
- IP-FORWARD-MIB
- TCP-MIB
- UDP-MIB
- HOST-RESOURCES-MIB
- ENTITY-MIB —Three MIB variables are supported on the ENTITY-MIB:
- Product ID: entPhysicalModelName
- Version ID: entPhysicalHardwareRev
- Serial Number: entPhysicalSerialNumber
- DISMAN-EVENT-MIB
- NOTIFICATION-LOG-MIB
- CISCO-CDP-MIB
Thank you
Abdel
- Labels:
-
Identity Services Engine (ISE)

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2017 02:32 PM
Hi Abdel,
Not sure what version of ISE you are running. Here is the information from ISE 2.2 on traps
Here i the information on MIBs and OID's supported
You can use SNMP poll for any SNMP manager to gather information from the MIBs.
Hope this helps.
Thanks
Krishnan
