How to Reset to Factory Default Room Navigator

[michael.enriquez]

How to Reset to Factory Default Room Navigator

We cannot connect the Room Navigator to the Codec, previously paired with the codec via ip address

[Pointbreak]

Press and hold the mute button for 10 to 12 seconds, when  it starts blinking , press volume down twice.

[Wayne DeNardi]

There is a factory reset pinhole on the back of the Navigator (near the microUSB port).  Insert an object (like the end of a paperclip) in to the hole and hold it in for around 6 seconds.  The device will reboot and you will be able to start the setup process again.

[George Sotiropoulos]

In addition to what Wayne described above to proceed with Factory Reset you  may try press and hold (5-10 seconds) on the room name in the upper-left corner of the screen.