Application Networking

HI AllI am facing an issue with a WAAS Central ManagerI can access it via Telnet, but when I try to access it  via https://<central Manager>:8443, i get the below error:Service Temporarily UnavailableThe server is temporarily unable to service your r...

Dear all  In my network I deployed Single-VLAN One-Armed Mode In this mode,the real server’s default gateway is the upstream router. To ensure the returnflow traverses back through the load balancer, the IP address of the client isrewritten to that o...

I've run into an interesting problem trying to migrate my production config from my redundant ACE20's (A2(3.4)) to the new ACE30's (Tried (A4(1.0) and A5(1.0)).  Everything on the ACE30 is working fine with a base config, but when the restore all is ...

Hi GuysFirst of all i am bit new to the ACE so apologies if i am being too silly.Basically i have around 10 URLs. What load ACE 4710 is doing its just forwarding everything to couple of servers. What we want is basically all requests which will come ...

Hi, Working with our Cisco SC, we are trialling vWAAS acceleration of Citrix traffic on UCS environment and using vPATH on Nexus 1000v to redirect traffic to the vWAAS accelerator. We have previous experience with WAAS physical devices, but first tim...

Hi Folks,First of all I am new the job and have very little ACE expierence. I work on a large campus. We have to 6513's with an ACE blade in each. A few contexts configured for different applications. Basically the server guys have come to me and ask...

Re:  Access Server through VIP (ACE 4710) but very slow Hi ShivaKindly  Help .....Accessing the server very slow.., Plz check my real  configuration... this configuration is for application server and after  this i have to configure more serverfa...

Hello,After migration some of apllications didn't work correctly. I troubleshooted the problem with the length of http header. The question is why the problem occur after migration? As I checked the default value of header-maxparse-length didn’t chan...

Hi,I am using Cisco Application Network Manager 5.2.1. I imported successfully a gss and a 6500 switch/router.I can see the ACE module within the 6500 but the import button is disabled. I have no idee why or what to do to enable it ?!A snapshot is at...

How do I configure the WAN-Bridge wan emulator on an ESX server?On ESX 4 I have WAN-Bridge booted and running.- eth0 is connected to port group 10 - PG10 is the only PG on a standalone vswitch - this vswitch is connected to vmnic 1.- eth1 is connecte...

Hi,I have for example a site http://abc.com which response back with the port on which it's being used on the server ex: http://abc.com:9081How would I rewrite the response remove the port on the server that is being used.Thank you,

Hi all,when i Acces my central manager i get the following messages regarding clock synchronisation with WAAS express devices.WAAS Express clock needs to be synchronized with the primary CM to make time-sensitive feature statistics work correctlyboth...