Application Networking

Hello,I have 7341 and I am reaching the connection limit. I want to read more about the loadbalancing WAE 7341 with 512 and 612 appliance. Is it possible to loadbalance between cross platform, if it does, how wccp knows that 7341 has 12000 connection...

I have two ACEs in an FT configuration. Each ACE is in a different building. The production context VLANs have typical FT configuration with IP address, peer IP address and alias. I'd like to place the Admin context (using G 1/4 as an access port) on...

ACE module reload sudden , i need to know what is the cause of this kindly provide me how can i know the cause

I need assistance getting FTP inspection to work with NAT.NAT is working, but not with FTP inspection.  When the client issues the PASV command, the server reply contains the original (not nat'd) IP address.  For example this is what the client sees:...

FolksI have a situation where I am not using persistent rebalance on ACE and what happens is that the server does not stick to the same server. Now if i enable persistent rebalance it does stick to the same server but load runner tests fails. This si...

Hi,Will ACE 4710 support for IPS features? Regards,Lingaraj R N+91-9920944501

    Hello,Am I able to use an SSL cert in the proxy list for the same VIP but on a different port?     Basically, can I use the same cert twice?Thanks,Dave         

Hi , We are managing almost 20 ACE in different location in HA mode . Right now the configuration is for redundancy in  ft group and ft track in user context and this redundancy are working well good .  Last week  i tested the track interface and ho...

Hello Everyone,I have ACE10 Module in my switch core 6509, my context "Proxy" was criated for balance connections to Forefront TMG Servers, this balance needs original client IP Address connections end to end in the solution.My problem is: The client...

                  I have a pair of ACE 4710 and I think I have all the failover configured correctly and it all appears to be working.  My question is regarding setting QOS on the physical interfaces that are part of my port channel.  I have qos trus...

I have a Cisco ACE 4710 A5(1.2). Scenario: Inbound call from PSTN to SIP Phone. Call comes into the VIP and then load balances to sip server, the server then routes the call out via WAN to the SIP phone as below:PSTN SIP Providor >(router)> ACE4710 >...

Hi AllI have 2 ace modules in seperate 6500 chassis, one admin context and 2 production contexts, One FT peer configured and 2 FT groups.All seems to work ok, but we had a power down on one of the 6500 chassies last weekend and after the ace module r...