Application Networking

Am trying to replicate the managment interface functionality of a CSS on ACE 4710 but have problem with it being treated as a general routed interface.ScenarioOn ACE 4710 I have a front-end interface for client facing VIPS and a back-end interface fa...

Hi ,I tried to change my main switch devices few month ago, but I couldn't. because the new devices not support to the WAAS.Recently, CISCO has released new S/W for the new device to support WAAS. The new S/W only support the WCCP version 2.If we...

  WCCP router 10.10.177.133 unusable for service id: 61 reason: Assignment method mismatch with router   WCCP router 10.10.177.133 unusable for service id: 62 reason: Assignment method mismatch with router   10.10.177.133 is the loopback of the route...

Hi All,I have recently configured a pair of ACE 4710 appliances in a FT group. The ACE's are deployed in one-arm mode, using Source NAT, with all routing to and from being done by a pair of PIX firewalls.My configuration does not include the use of a...

My WAAS deployment is currently at 4.4.5 and I just got a hold of 4.5.1 through my account manager. Not sure if I can do a direct upgrade or not since the release notes for 4.5.1 states the following:Upgrading to Version 4.5.1 is supported only from ...

We are currently running ANM server version 4.1.  I am trying to upgrade to version 5.1.  But when I run the "application upgrade anm-va-5.1.ova Upgrade" command, I receive an error that states:  "Manifest file not found in the bundle" I then tried t...

                   Hello All,I have the scenario below and the comunication between the Routers and Core Switchs are in a load share way witch means that we will have asymmetry on the WAAS below. How can we avoid it ? is there any specific configurat...

Hi All,I configured ACE 4710  for HTTP traffic. All applications are running through real server. But when I run the same applications from virtual IP i.e through ACE. some applications are not running. Particularly applications having XML.Is it ACE ...

Hello team:I am going to configure an ACE in bridge mode. In parallel to building a VIP to balance the server farm, my customer wants to reach the servers by their corresponding real IP addresses for management purposes.¿ Will ACE grant access to the...

Hi, I have a new deployment I am working on.  I am unclear on the Inline setup. One location is configured as a trunk between the router and the switch, with voice and data traffic going through it. We will be installing a 294 inline at this site. Wh...

Hi all,We have ACE module (ACE20) in our DC. The startup-config file is located in flash memory which should be disk0: as I read in all the documentation. But how can I see that the file is there? ace-wwsf1/Admin# dir disk0:     1024  Sep 11 17:12:17...

Hello,I am trying to audit an existing configuration of CSM module. Unfortunately have not an experience in CSM module configaration.The main goal is to understand if there are any direct connection between servers in different serverfarms (i.e. serv...

Need some help in understanding the  priority value , below is my ft track host conifg  and the outputft interface vlan 1003  ip address 1.1.1.1 255.255.255.252  peer ip address 1.1.1.2 255.255.255.252  no shutdownft peer 1  heartbeat interval 300  h...