Application Networking

Hi ,Since couple of weeks , i am getting below DOS attack logs on cisco CSS.Can anyone help me out about how can we avoid this? and how to deal with it.04/23/2011 17:27:28:Enterprise:DOS Attack:SYN Attack -> 10 times04/23/2011 17:30:15:Enterprise:DOS...

Hi All I would like to keep connection table of ACE from "show conn" command. Is it possible to keep it internally or export to external?Thank so muchPichet

We have configured two ACEs with high Availability. ACEs link with our cores, switches cat6500, through a port-channel, ACE’s ports G1/1 and G1/2. High availability works fine if some vlan down but it doesn’t work if an interface down, only if both ...

Hello.We have some implementations of Blue Coat cache with layer2-WCCP configuration on our routers.  Now we have a new requirement to configure GRE-WCCP between a Cisco3845 router and a cache-engine, which sits several hops away from the router.  Wh...

I have been trying to load balance ftp through the ACE SM.  Active FTP works fine.  Passive FTP fails every time and I cannot for the life of me figure out why.  The context is routed and I have included the relevant config for the FTP farm.  Can any...

Dear Team,One of our CISCO ACE is faulty and now we got the replacement for that. Should I have to raise any request to do license transfer??Please let me knowRegardsBR

Hi,We have ACE 4710 inslatted in 1-Arm mode deployed in DC where it is load balancing DC servers properly. Now my management wants to load balance the DR servers as well using the DC ACE. Is this possible??

Hello,I have a trouble, the vip in the context intranet is 172.10.254.3 and when i make ping -l 500 172.10.243.3, the vip respond, but when i make ping -5000 172.10.254.3, the vip is not response. what happend?? i want to reach the vip, but when the ...

Hi guys, I need to implement   two datacenters on different location. I have a little question. Scenary: Both Datacenter will have cisco nexus 7010 in the core, and I need to configure two ACE in each site. My  question is,   can I configure 2...

Is there a way to have a signed certificate for the CM management GUI itself? and how do I configure that?

I'm having an issue setting up wccp between WAE674 and ASR1000.  When I run "show wccp router" from WAE, router is not recognized as one that is configured and seeing by WAE.  I can ping the router from WAE.WAE674 - 4.1.1d.7ASR1000 - 15.0(1)S2WAE was...

Hi All,We are seeing Minor alarm unsupported_client in some of the WAE. When i did alarm detail support it shows no action required. But I would like to understand why the alarm is created. We have not seen in the previous code 4.1.5f.abcdwa1#sh al d...