Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,My CSS got rebooted today without any changes been made. The device was working perfectly fine but suddenly we say the device going down morning 8:00,.Logs shows :-OCT 14 07:59:00 1/1 501413 FP_DRV-4: PrismFastPath::TxPacketToQueue: Queue Writ...
Hello,I tried to create a rserver on the standby VC on the ACE module using ANM. This rserver is displayed in the ANM (the transfering is done without any error message), but this rserver is not created on the standby VC. It is OK, but why the ANM di...
How does the ACE handle an rserver initiating a connection to the outside, in L3 routed mode?The default gateway for the server is the ace server-side svi.Say i go to google.com on an rserver - does the ace just just become a router and allow the con...
Please see the below ACE configuration. It is currently in place for both load balancing and redirection. Here are the 4 current scenarios...1. https://www.URL1.com is the desired URL and will be load balanced. Certificate is for this URL.2. http:...
I am a new to ACE appliance 4710. I tried to configure it based on the Cisco Doc. But I could not access servers behind them. Our topology is:ASA-------vlan 28(10.248.28.0/24)--------ACE-----Vlan30(10.248.30.0/23)-----Web servers.I setup another virt...
Dear All,I want to make a CSR on ace for multible SSL Certificate. I have looked everywhere and there is no documentation of how to do this.what i want to do is create one CSR Request to Verisign for SSL for sites www.xxxxxx.com, www.yyyyyyy.com and ...
I would like to setup two GSS in an redundant mode i.e. with same DNS rules. If one fails other should start servicing the DNS requests. Both the GSS would be at two different locations and only one would service the requests at any point in time. So...
Hello All,I'm using a Cisco WAN emulator in my LAB to simulate a WAN link of 4Mbps with 250ms delay. When I FTP a large file, I'm getting just above 2Mbps and seeing a lot of output packet drops on the WAN interface. It doesn't ever fill the pipe unl...
HelloI wanted to know of there was a way to export the .pfx files off of the SSL Module to an SFTP server.....preferably in bulk not one at a time. I want a central storage location for these files in the event that the CSS or the SSL module crashes...
Is there an easy way to update a cert file using ANM? Currently I delete the cert file using the CLI, TFTP the new cert on via ANM so it goes to both modules, and then have to delete class-map and then re-add it to make the cert take in the CLI. Go...
Currently I have bunch of WAE 511, 512, 612, 674 and the CM are all running on the 4.1.5f. Since the WAE 511 is going to be EOL, I'm going to replace some of the old 511s with 574/674 but these new WAEs are shipped with 4.2.3. Would that be a probl...
Hi,I have an WAE-274 with failing HD, new RMA is on the way.A question about this WAE-274.If I did an "sh run" or an "sh start" I was unable to see the interface GigabitEthernet 1/0.The interface InlineGroup 1/1 was there.sh disk det was saying missi...
Hi,I would be giving a WAAS PoC to one of our client next week,I have few queries before I implement this PoCTraffic which need to be optimized Citrix Traffic, File server , Antivirus Update and other customized applicationNetwork Setup :2 Datacenter...
