Application Networking

After upgrading ACE module from A2(3.1) to A2(3.2) we started getting complaints about the ablity to upload a file in one of our applications. We are able to recreate the problem and noticed that when there is a failure, the ACE sends a TCP RST in bo...

I am looking and just not finding instructions on backgrading a NME-WAE-502-K9 from version 4.2.3 to the current version I have of 4.1.5. I've found documents on upgrading but not any for back grading.Thanks in advance

Hi,We got duplex problem again "new site" for the inline port WAN0, LAN0 is ok.We have tried crossover and straight through cable, without any look still 100/ half duplex.The PTT router int fa0/0 have been to 100/full and auto/auto still 100 half in ...

Hi,I have a loadbalanced HTTP server which loadbalances between two rservers. Is it possible to rewrite the http header based on which rserver the request is going to ?Following is a part of the config to explain.-------------------------------------...

Hi all,I have a CSS configured as a load balancer for multiple VLANs using trunk mode. VIP and server are on VLAN1. Users can access the VIP from VLAN1 (no firewall in this case); users can't access the VIP from VLAN2 (cross firewall). Firewall allow...

Hello,does anyone know the multicast address which the ace use to sync theconnection entries over his ft vlan ?GreetingEd

With an ACE SM in the cat65k configured in routed mode and the real servers' defaul gateway being the server side Layer 3 VLAN int on the ACE, when the real server initiates the connection, does it go to the MSFC-ACE-server side Layer 3 VLAN int or d...

I want to configure SSL termination on cisco LB. i just want to know is there any license required for this deployment ? please share me some configuration steps to deploy the SSL.ThanksIrfan Hussain

Hello EveryoneI'm seeing the following on EPM connections and was wondering if this is normal. Version 4.2.1.D:DRE,L:LZ,T:TCP Optimization RR:Total Reduction RatioA:AOIM,C:CIFS,E:EPM,G:GENERIC,H:HTTP,M:MAPI,N:NFS,S:SSL,V:VIDEOConnID        Source IP:...

ACE module had bit flip and it was hunged after that.I was not able to run any command(i.e For ex if i run show ft status nothing was displayed).I was not able to run any command on the standby ACE as well is this could be both the ACE module ACTIVE?...