wilfred malana
Level 1
Level 1
Member since ‎07-07-2005
‎10-17-2018

User Statistics

  • 61 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
40 Discussion Posts
5 Discussion Posts
50 Discussion Posts
30 Replies
30 Discussion Posts
60 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts

User Activity

I am trying to reverse the effect of this following following regex;.office@{User.emailAddress['^.+?@'='']}This particular regex is from the Jabber provisioning doc. What I am trying to accomplish is to strip out the domain from the email address or ...
This is on CUCM 8.6, the DN in question is a DID from a SIP provider terminated on a 2811CUBE (not sure  of that is pertinent).When I call the DID, it rings on phones that have that have that DN assigned to. But I can not answer the call. It will sto...
Here's my setup.VOIP.MS (DID) ----> ISR 2811 (CME 7.1) ----> CUCM8.6CME has one 7940 phone ext 2000 CUCM has 7962, 9951, 8961 phones ext 1000-1006I appreciate the help.CUCM and CME integration works ok. I can make internal calls from CUCM to CME and ...
Got CUCM 8.6 running with 3x 9951 and 2 x 7962G phones. They are set up with extensions 100X. I am also using CME 7.1 to terminate my voip.ms SIP trunk, CME has a single 7940 phone (ext 2000). I already setup dial-peers in CME and h323 gateway in CUC...
Just received a 4510RE w/ SUP7s which will start rolling out at the access layer in place of 6500 chassis. I ran into an issue creating port-channel interface with the 10GigE uplinks. Sitching the port-channel to L2 or L3 doesn't seem to make a diffe...
Community Statistics
Member Since ‎07-07-2005 12:19 PM
Date Last Visited ‎10-17-2018 01:21 PM
Posts 61