Application Networking

I'm trying to setup WAAS between 2 sites. Site A with dual WAN routers and Site B with single WAN router. Site B will have 2 tunnels connecting back to Site A as per attached topology. I'm facing some issues here whereby I'm not able to access applic...

Hello everybody!!! I have a problem with my wave-574. It doesnt respond anything. I've tried to connect via telnet or console cable, tried to reload by pulling out the power cable but nothing had change. Only power button led is amber and others are ...

Hi, I have been using my ACE for several years, it is in front of a Varnish reverse proxy. Recently I have noticed something strange. I am seeing some of Timed-Out and Failed connections : +------------------------------------------++------- Connecti...

Good Evening All, I'm suddenly having issues with a VIP configured on a Cisco ACE module.  The VIP suddenly stopped responding to pings and is not serving content except for what looks like sticky connections.  The VIP has 2 real servers each averagi...

Dear Cisco Support, This is my first time for sizing waas, i want to ask few questions. I am designing for 500 remotes routers and 4 DC ASR routers - 3 DRC ASR routers, Wave as central manager in DC and DRC. 1. What happen when the connection of user...

Hi: i am upgrading Nexus 5000 IOS first time. when i  check upgrade impact , i am getting the upgrade is disruptive. can any body guide me what does it mean. Is it minor impact or need a switch reload. Thanks for you time. Compatibility check is done...

Hello, We noticed really strange behavior of interface counters. On Port-Channel where are physical interfaces of ESXi host we can see this:  300 seconds input rate 52649472 bits/sec, 27102 packets/sec  300 seconds output rate 240516680 bits/sec, 662...

Hi All, Do we have a equivalent command in nx-os (7000 series) for ip tcp adjust-mss or an alternate way? Please advice. Thanks in advance, Nagasheshu.

Good Morning! You can perform traffic shaping configuration on the Nexus 7000 and set the IP source and destination? What would be the setup to do?

Hello, Scenario, Data Center with several Remote Locations connected by private WAN. Current Software Version: 5.5.5a > Upgrade to 6.1.1.26 Data Center holds CM (VM) & OE694 (Appliances), upgrading CM no problem all good - upgrading OE694 Bios&Softwa...

Hi folks,   we have a WAAS with the following specs...   Model: WAE-674-K9 Memory: 8192MB Device ID: 00:21:5e:56:5a:24 License: Enterprise Interception: Inline   The WAAS has to bypass/pass through traffic destined for the IP’s of 108.171.133.133 and...

During the Initail SETUP config in Acceleration Engine, it generally ask for single Central Manger IP Address (e.g Primary CM IP =10.6.1.100 & Secondary CM IP = 10.6.1.101) i.e we provides Primary central Manager's IP address (here it's 10.6.1.100). ...