Application Networking

Got a new ACE 4710 and am I new to the appliance. I am testing out a senario with load balancing between two servers. In testing when I ping the VIP ip address the replies I see are from the real server ip addresses. I am just wondering if this is th...

Hi,I want to apply new policy on the WAVE-574 to bypass the optimization for the certain traffic flows (traffic from 192.168.1.0/24 to 192.168.2.0/24 not to be optimized). I've prepared the configuration according to preconfigured policies which look...

Hi all,I have a WAE-674 and initially I configured it to use WCCP for traffic interception but now I decide to use inline and I've got an inline module installed. Is there any configuration changes on the WAE when changing from WCCP to inline ? I've ...

At first we were unable to ssh to ACE.Logs show:Jun  1 2010 08:32:07 : %ACE-1-106028: WARNING: Access rules memory exhausted while processing merged list. Incomplete rule is currently applied on interface vlan533.  Manual roll back to a previous acce...

Hi,I'm preparing for WebNs upgrade from 7.4 to 7.5 to 8.2And change will be done remotely.My question is, what will happen if the new code doesn't boot up after we reboot the CSS?Will it auto fall back to the previous working code?Thank you.

For business logic, I must regards as server crash as a normal case, that can not make the serverfarm's state be PROBE_FAILED.

Hi,I was wondering what was the best practice for the access-list's on the Cisco ACE.Should we permit Any in the access-list, and classify the traffic in the class-maps as seen in a brief example:access-list ANY line 10 extended permit ip any any acc...

Can someone help me out here?I have an ACE operating in Layer-3 mode, behind a Checkpoint firewall.I've attached a network diagram as well. All my hosts are RedhatLinux Enterprise Server version 3From Linux_1, I can sFTP and scp upload/download file...

Hi,I have a CSS11503 that is rebooting on a regular basis, in the log it shows the followingMAY 27 22:30:31 2/1 1 SYSSOFT-0: ONDM: Sub-Module in slot/sub-slot 2/1 failedMAY 27 22:30:34 1/1 107 SYSSOFT-3: ONDM: LifeTick for Sub-Module in slot/sub-slot...

Hi all,Is Central Manager with software version 4.1.5d (or 4.1.5e) supported when combined with WAE 7341 with software version 4.0.19 ? I am specifically using 4.0.19 cause I need to perform a demo showing Replication Mode ?Thanks in advance.

is there a roadmap (date) to release the 4.2 waas software version?